New line of FullPower lipo batteries, with more power thanks to the greater number of discharge C. This makes the new FullPower V2 batteries even more advantageous in terms of cost / performance.
For good performance and durability of Li-Po battery packs, it is recommended to balance them during charging using appropriate instruments.
All FULLPOWER packs are supplied with balancing plug type JST-XH and power plug (up to 850 mAh type BEC, besides type DEANS, EC3 or XT-60)
The Fullpower batteries are suitable for a charge up to 5C (five times the battery capacity) despite this, if there is no particular urgency, a maximum 1C charge is recommended, this - and it is valid for all types of batteries - lengthens it life considerably.
WARNING, READ CAREFULLY BEFORE PURCHASING:
Batteries, electric motors, propellers and models are highly technological products but potentially dangerous for things, animals or people, especially if used improperly or without experience. By purchasing these products, the buyer assumes all responsibility for the risks listed below, agreeing not to hold the producers, distributors, or retailers responsible for any accidents to things, animals or people.
- After use, always disconnect the battery from any circuit (speed regulators, etc.), these generally continue to absorb energy even with the power switch turned off, excessively discharging the battery and damaging it beyond repair.
-For connections to the drive and the motor, only use connectors with gold-plated contacts suitable for absorbing the system, DO NOT USE LOW-QUALITY "FASTOM" OR SIMILAR CONNECTORS!
Li-Po batteries require specific requirements for recharging and battery chargers must only be used with Li-Po cell settings.
The best chargers are those that require manual selection of the number of cells and charging current for each battery pack and then automatically check that the settings are correct.
Many chargers are manually programmable but may not have a safety circuit that controls the settings. An incorrect setting of the charger can cause damage to the battery with consequent risk of fire.
It is strongly recommended not to exceed 4.2V per cell in charge and not to fall below 3.3V per cell in discharge, otherwise the battery will rapidly deteriorate.
The Fullpower batteries are suitable for a charge up to 3C (three times the battery capacity) despite this, if you have no particular urgency, a maximum 1C charge is recommended, this - and it is valid for all types of batteries - lengthens it life considerably. However, it is advisable to carry out the first 2/3 charges at 0.5 or 1C.
For a good yield, durability and SAFETY of Li-Po battery packs it is recommended to always balance them during charging using appropriate instruments. FullPower batteries are equipped with a JST-XH balance connector.