Description
IFS receiver in DX technology for connection of 6 servos.
The programming of the receiver, e.g. failsafe settings or canal switching, is done exclusively by wireless communication via the XZ-P1 IFS programming device. order no. 23300.
Info
DX technology With DX technology, the receiver has a new high-frequency unit with state-of-the-art components. For reception, a hardware aerial diversity system always switches to the better antenna signal and, for transmission, always uses the aerial that was last used for reception.
The receiver operates even at voltages of about 2 volts. Thus, even when the batteries are getting weak - e.g. at the end of flying time - it is resistant to voltage drops due to high servo currents.
In the XR-16DX IFS and XR-20DX IFS receivers, an expanded low voltage monitor has been implemented in 3 stages.
The LED status display shows violet below a receiver supply voltage of 3.5 volts, blue between 3.5 and 4 volts, yellow between 4.0 and 4.5 volts, and green at over 4.5 volts.
Compared to the previous receivers, the weights have been reduced; and the receiver input sensitivity and thus the range have been increased further.
Horizontal or miniature servo connections facilitate installation in tight quarters.
Specification
Temperature range : -15...+55 °C
Aerial length: 2x22 mm
Aerial : Dipolantenne
All-up weight, approx.: 5 g
Frequency : 2400 ... 2483,5 MHz
Range approx. : 1000 m
Dimensions (LxWxH): 37x20x11 mm
Modulation: 2,4 GHz FHSS
Charging rate : ca. 25 mA
Operating voltage : (2,1) 3,5 ... 10 V
Τηλ: 210 5444 204 - Φαξ: 210 5444 384
e-mail: info@diamond-models.gr
Διεύθυνση: Κοραή 8 & Καποδιστρίου
Αιγάλεω 122 41 , Αθήνα
Ώρες Λειτουργίας: Δ-Τ-Τ-Π-Π απο 9:30-20:30 Σαβ.απο 9:30-15:00